Salt, Mineral, Hardness and Conductivity Tester Digital Multi TDS Meter

The TDS meter is used to measure the saturation of liquids with salts and minerals, measure the level of hardness, and electrical conductivity. Using this analyzer, you can check and evaluate the quality of water filters. The device is as compact as possible, has an informative display and high accuracy when taking measurements.

Peculiarities:

- Professional combination of salinity meter, conductivity meter and temperature meter.

- Large LCD display, titanium alloy movable electrode, quick measurement of salt concentration, conductivity and temperature.

- The hold function makes it much more convenient to take and record readings. Press the HOLD button to freeze or clear the current display reading.

- Auto shut-off function to save battery power. Timer for 5 minutes.

- Automatic temperature compensation, 3 temperature coefficients for more accurate measurement.

- Measuring range 0-9990 ppm, 0-9990 mS/cm, 0 - 80.0°C, 32.0 - 176.0°F, accuracy ±2%.

Mudder Digital Multi TDS Meter allows you to measure salt concentration, electrical conductivity and water temperature. It is portable and has a convenient removable cap. The set includes a leather case. You can carry the device right in your pocket.

How to calibrate your device:

The device uses virtual resistive calibration. This is convenient, since the device setup is very stable and does not require calibration. However, if you require higher accuracy, you can calibrate the meter as follows:

Step 1: Clean the electrode using distilled water, a special Na CL solution (342 ppm) or a special calibration fluid.

Step 2: Dip the electrode into the liquid and check the value shown on the display. If the value is more than ±2% off, you will need to calibrate.

Step 3: Open the analyzer cover and locate the adjustment slider.

Step 4: Set manually to 342 ppm and close the lid. After this, clean the electrode again.

Step 5: Run the test again and make sure the meter displays a result of 342 ppm.

How to switch device modes:

- How to switch between salinity meter and conductivity meter: Press SHIFT button to switch mode. Initially, the salinity meter mode is used.

- How to switch between Celsius and Fahrenheit: Press SHIFT button to switch mode. Initially, degrees Celsius are used.

Equipment:

TDS Tester water hardness in a case - 1 pc.

User manual - 1 piece.